ypp_nl and ypp_rt processing stops on the optical step and G-vector setup

You can post here problems arising when using the last release of Yambo. Issues as parallelization strategy, performance issues and other technical aspects realted to the new release.

Moderators: Davide Sangalli, Daniele Varsano, andrea.ferretti, andrea marini, Conor Hogan, myrta gruning

Post Reply
AmberLee123
Posts: 4
Joined: Sun Jul 26, 2020 7:00 am
Location: Xiamen, Fujian, China

ypp_nl and ypp_rt processing stops on the optical step and G-vector setup

Post by AmberLee123 » Sun Jul 26, 2020 3:00 pm

Dear developers:

I am trying to repeat the work on "Real time approach to linear response" (http://www.yambo-code.org/wiki/index.ph ... r_response) and got stuck on the ypp_rt and ypp_nl .

The problem is in the Results Analysis part, both ypp_rt and ypp_nl stops in the optical calculation. Which can be found in the tar ball.

I start from hBN-2D-RT.tar.gz and the "Setup" step in http://www.yambo-code.org/wiki/index.ph ... with_Yambo .
Also another question is that in this prerequisite step after reduce G-vector,

" MaxGvecs= 1001 RL # [INI] Max number of G-vectors planned to use"
yambo -D still gives the same G-vector number as before.
G-vectors [RL space]: 18475

The LIST_Log file is too large to upload, and it can be download here:
link: https://share.weiyun.com/O3Ortalc pw: zbo582

Best,
Dr. Guoyu Yang
School of Science, Jimei University, Xiamen, Fujian, China.
You do not have the required permissions to view the files attached to this post.
Dr. Guoyu Yang
School of Science, Jimei University, Xiamen, Fujian, China

AmberLee123
Posts: 4
Joined: Sun Jul 26, 2020 7:00 am
Location: Xiamen, Fujian, China

Re: ypp_nl and ypp_rt processing stops on the optical step and G-vector setup

Post by AmberLee123 » Fri Jul 31, 2020 2:17 am

Dear Yamboers,

I switched to yambo 4.5.2 , and the problem disappeared.
Thanks a lot~
Dr. Guoyu Yang
School of Science, Jimei University, Xiamen, Fujian, China

Post Reply