On the calculation of molecules and cluters

Forum for discussing issues arising with interfacing the Abinit code (KSS) file with Yambo.

Moderator: Conor Hogan

Post Reply
ganymede
Posts: 1
Joined: Sat Mar 21, 2009 4:59 pm
Contact:

On the calculation of molecules and cluters

Post by ganymede » Mon May 11, 2009 6:42 pm

Daer Yambo Developers and users:
I have a bit confusion about the calculation of molecules and cluters use ABINIT,
First, on the groundstate calculation, if the system(molecules or cluters)have N number ofvalence electrons, which number of nband i should choose? or this choose is enough nband = (100% + 20%) of (valence el.)/2 ? or i shoul make a test?
Second, for generation the KSS file, the same confusion , which number of nband2 and nbandkss shoul i choose?
Thanks very much!
ganymede

User avatar
myrta gruning
Posts: 305
Joined: Tue Mar 17, 2009 11:38 am
Contact:

Re: On the calculation of molecules and cluters

Post by myrta gruning » Mon May 11, 2009 7:17 pm

Hallo Ganymede,

:!: first of all, remember to fill in your signature :!:

In general for the ground state DFT calculation (the scf step) you just need the occupied bands. Usually some more are added, but their number should not affect the calculation. Special care is needed in the case of metalic systems, but for systems with a finite gap should not be any complications and in the case abinit you may even use the default value.
To generate the kss, take nband2 and nbandkss2 equal. You do not know in advance the exact number you need to get a converged calculation. This depends on the systems and the properties you are calculating and you will need to test it.
Choose a pretty large number, if it is not enough you will have to generate a new KSS (note that you can start from the old one).

Cheers
m
Dr Myrta Grüning
Atomistic Simulation Centre
Queen's University Belfast - Northern Ireland

http://www.researcherid.com/rid/B-1515-2009

Post Reply